A bunk bed collection sounds like a quick job, and the driving part usually is. The hard part is the bolts. Second-hand bunks come apart into a dozen pieces, and one missing fixing can stop the whole rebuild. So when parents ask about van hire in Warrington for a set of bunks, we talk about dismantling first. This guide covers both, plus the checks that make the bed safe again at home.
Which Van Suits a Bunk Bed Collection

Most bunks break down into two end frames, four side rails, slats, a ladder and a safety rail. None of those pieces is heavy. However, the side rails are long, and the end frames are tall and wide. A car rarely takes them without folding seats flat and pushing parts against the windscreen. That is unsafe and usually scratches the bed.
For a standard set of bunks, a short wheelbase low roof van is normally enough. The rails lie flat on the floor and the end frames lie on top. Bringing two mattresses or a cabin bed with a desk as well? Then step up to a short wheelbase medium roof van. The extra height lets mattresses stand on their edges, which keeps them clean and flat.
New bunks bought from a store come boxed, and the boxes are long and heavy. Carry them flat between two people and slide them in along the van floor. Check the box count against the receipt before you leave the collection point. A bed often ships in two or three boxes, and leaving one behind means a second trip.
Dismantling Bunks Before You Load
Arrive with the right tools. Most bunks use hex bolts and barrel nuts. So bring Allen keys, a screwdriver and a socket set. Ask the seller in advance whether the bed is still assembled. If it is, budget half an hour to take it apart carefully. Rushing is how barrel nuts drop into carpets and vanish.
Before you undo anything, take photos from each side. Then label each piece with masking tape, such as “top left rail” or “ladder”. Next, remove the ladder and safety rail, then the slats. Lift off the top bunk as a unit if the design allows. Finally, separate the end frames from the side rails. Two people make this much safer, because the top bunk can tip as the last bolts come out.
Bagging Bolts and Fixings
Every fixing goes into a sealed freezer bag the moment it comes out. Use one bag per joint, or at least one per end of the bed. Write on each bag where it came from. Then tape the bags to the matching piece of the frame. That way, the bolts travel with the part they hold together.
If the bed is second hand, count the fixings against the instructions if the seller still has them. Missing bolts are often easy to replace from a hardware shop. However, it is much better to know before you drive away. Finally, put any spare parts, keys and leaflets into one envelope in the glovebox.
Loading Mattresses and Long Side Rails
Mattresses travel separately from the frame. Wrap each one in a plastic cover or a clean sheet so it stays dry and dust free. Stand them against the side wall of the van, strapped at two heights. Never lay rails or frames on top of a mattress, because the edges can dent the springs.
Lay the side rails flat on a blanket, side by side, with the bolt bags facing up. Next, lay the end frames over them, padded with another blanket. Strap the stack to the floor tie points so nothing slides on a roundabout. Pack a couple of old duvets and some straps of your own, as the van comes empty. Slats can travel rolled up and taped, or tied in a bundle.
Bunk Bed Collection Routes and Driving
Many second-hand bunks come from family homes on the newer estates around Birchwood. Our page on van hire Risley covers that side of town. Closer to the centre, van hire Longford covers the streets to the north. Either trip is short, so a morning hire is usually plenty for a single bed.
Both SWB vans drive much like a large car. Every van in our fleet is also 3.5 tonnes or under. So a standard car licence covers them. If you want to check what your own licence allows, read the government guide to driving licence categories. Even so, take speed humps gently with a loaded van, because loose frames rattle and mark each other.
Rebuilding Safely at Home
Rebuild the bed in the room it will live in, using your photos as a guide. Tighten every bolt firmly, then check them all again once the bed is complete. Make sure the safety rail runs along the full open side of the top bunk. Then check the slats sit properly and the ladder hooks on securely. A wobble at this stage means something is loose. Keep the children off the top bunk until an adult rechecks every bolt the next morning. New joints settle overnight. Refitting a whole bedroom? Our guide to wardrobe van hire for fitted furniture covers larger pieces. It pairs well with a bunk bed collection on the same day.
Our depot on Tilley Street opens from 8am to 4pm, Monday to Saturday, closed Sunday. You will find it at the main entrance to Cockhedge Shopping Centre, with free secure parking on site. Bring your photocard licence and a DVLA check code. No deposit applies on most vehicles. Planning ahead? Then our van hire special offers include 10% off selected vehicles booked at least two weeks ahead.
Tell us what you are collecting and whether mattresses are coming too. We will then suggest the right van from a fleet of over 70. Give us a ring on 01925 396 222 to book, or drop the details into our contact us form.
